cm11.pm - Possible code problem

classic Classic list List threaded Threaded
1 message Options
Reply | Threaded
Open this post in threaded view
|

cm11.pm - Possible code problem

Peter W-2
After upgrading to 2.101 from 2.97 noticed an unusual problem with my X10.

When I send a command to code C16, device C3 turns on and off consistently. This did not occur in 2.97 with my present install.

Didn't change anything code wise. When I roll back to 2.97 the problem goes away.

I even swapped in my spare cm11a device to be sure, nope, same responses.

Only odd thing I can report is that I get an 'No response from Cm11, try sending an X10 command' error immediately after issuing a command to the C16 address, but not to any other device, and only in Version 2.101.

Peter


------------------------------------------------------- This SF.net email is sponsored by: Splunk Inc. Do you grep through log files for problems? Stop! Download the new AJAX search engine that makes searching your log files as easy as surfing the web. DOWNLOAD SPLUNK! http://sel.as-us.falkag.net/sel?cmd=lnk&kid=103432&bid=230486&dat=121642 ________________________________________________________ To unsubscribe from this list, go to: http://sourceforge.net/mail/?group_id=1365