For a little while now I am experiencing intermittent delays when transmitting to X10 devices, here is a part of what I see in the logs, I have enabled debug for X10, but not sure how to read them!
Can you guys help?
I already tried replacing the CM11 thinking, from what I see at the bottom of this page, that it was defective, it does the same thing.
Not sure what to look for, the command “almost” always go through, but the delay drives me crazy, I use it to turn On lights with motion detectors….is there a writeup so I can figure out those X10 commands?
05/03/16 07:45:55 Lumiere garage fermee par IR
X10: interface=cm11 isfunc=0 save_unit=XAG data=XAG # (trying to turn off unit A16)